outdoors hunting camping SHTF GMRS radio communications antenna battery electronics scanners digital computer software hardware laptop iPad iPhone eBay music radio
.

 
Leixen VV-808S
single band

Programming Memories
Manually
 
  
 
 




Frequency Mode vs. Channel Mode

These two modes have different functions and often confused.

Frequency Mode - Used for a temporary frequency assignment, such as a test frequency or quick field programming if permitted.

Channel Mode - Used for selecting preprogrammed channels.

All programming MUST be initially done in the Frequency Mode only. From there you have the option of assigning the entered data to a specific channel for later access in the Channel Mode if desired.







Programming Repeater with Standard Offset

146.850 MHz
600kHz  minus offset
CTCSS tone 123.0
into channel 99
Change from Menu to Menu by turning the Rotary Tuning Dial on the left.
Once proper menu is selected, you can move from Option to Option the same way.

Set radio to VFO Mode   (Frequency)
 
      146850 [M]     Enter RX using microphone keypad
Menu
  34
[M] 000600 [M]     Enter TX offset (using keypad)
Menu
  35
[M] - RPT [M]     Select minus offset
Menu
  10
[M] CTC [M]     Select CTCSS
Menu
  11
[M] 123.0 [M]     Select desired TX encode tone
Menu
  30
[M] Power [M]     Select High or Low
Menu
   5
[M] 9 9  [M]     Rotate Dial to desired channel

 Return to MR Mode   (Channel Mode)
 
 
 
Programming a Simplex Channel

446.000 MHz
into channel 99
Change from Menu to Menu by turning the tuning Dial on the left.
Once proper menu is selected, you can move from Option to Option the same way.

Set radio to VFO Mode   (Frequency)
 
      446000  [M]     Enter RX using microphone keypad
Menu
  35
[M] SING [M]     Rotate Dial to select simplex
Menu
   5
[M] 9 9  [M]     Rotate Dial to desired channel

 Return to MR Mode   (Channel Mode)
 
 
 
Naming / Labeling a Channel
to appear in LCD
The following is a Radio setting (not a channel setting) that sets the radio to accept user defined channel names.  This only needs to be done once.
[M]   Menu 20   [M]   ON   [M]


Remain in MR Mode   (Channel)
 
Select Channel to be Labeled using rotary Dial.
 
  [M]     Enter Menu mode
Menu
  21
[M] ON [M]     Accept channel name display for that channel
Menu
  22
P2     Rotate Dial to select the Alpha Character
        to be displayed in position 1
  P2         Rotate Dial to select the Alpha Character
       to be displayed in position 2
  P2         Rotate Dial to select the Alpha Character
       to be displayed in position 3
  P2     Continue this process until complete name is entered.
Up to 7 characters can be displayed
  P3     Naming now completed for that channel





 
 

TOP of PAGE
 
Miklor Home
 
Miklor