outdoors hunting camping SHTF GMRS radio communications antenna battery electronics scanners digital computer software hardware laptop iPad iPhone eBay music radio
.

 
Wouxun KG-UV8D
  
Menu Definitions
    

1    STEP Frequency Step
-  Amount of frequency change when using Up/Down arrows or when scanning in VFO Mode.  
   Note: 2.5kHz not available on V1.01 *
  
2.5* / 5 / 6.25 / 10 /
12.5 / 25 / 50 / 100 kHz
2    SQL-LE Squelch Level
-  Squelch silences the receiver when there is no signal.
 
 
0 > 9
3    SAVE Battery Save
-  Receiver goes into a sleeping mode until a signal is detected.

 
 
OFF / ON 
4    TXP Transmit Power
-  VHF   High = 5 watts    Low = 1 watt
-  UHF   High = 4 watts    Low = 1 watt
 
 
High  5W/4W
Low  1W
5   ROGER Prompt at beginning/end of transmission
BOT  Prompt at Beginning of each transmission.
-  END  Prompt at End of transmission
-  BOTH  Prompt at Beginning and End of transmission
 
 
OFF /
BOT / EOT /
BOTH
6    TOT Transmission  Time Out Timer
-  Transmit Times Out after pre-selected time.
-  Radio will alert you when the time is up.
-  This helps prevent overheating.
 
 
15 / 30 > 600 secs
7    VOX Voice Operated Xmtr
-  Allows transmitter activation by talking only.
-  Adjust VOX gain to allow smooth operation.
-  Level  10  requires the strongest voice.
 
 
OFF /
1, 2 >
9
8    WN Wideband / Narrowband
-  Wide = 5 KHz    Narrow = 2.5 KHz
-  For Ham use, start with selecting Wide.
 
 
WIDE / NARR
9   VOICE Voice Prompt
-  Audible confirmation of a keypad entry.
 
 
OFF /
ENG / CHI
10   TOA Transmit Overtime Alarm (TOA)
-  Beep tone and LCD flashes X seconds before timeout setting.
 
 
OFF /
1, 2 > 10
11   BEEP Keypad Beep
-  Allows audible confirmation of a key press and audible warnings.
 
 
OFF / ON
12   LANGUAGE Display Language
   Chinese / English
 
 
CHINESE / ENGLISH
13   BCL Busy Channel Lockout
-  Prevents transmitting on a busy frequency.
-  If another repeater or signal is present using a different CTCSS or DCS code, your transmitter will be 'locked out' to prevent interference.  When PTT is keyed, radio will sound a Beep Tone.
 
 
OFF / ON
14   SC-REV Scan Resume Method
   TO (Time Operation) Scan stops when signal detected.
     Scan resumes after 5 seconds.
   CO (Carrier Operation) Scan stops when signal detected.
     Scan resumes 3 seconds after signal disappears.
   SE (Search Operation) Scan stops when signal detected.
     Scanning will not resume.

 
 
TO / CO / SE
15   R-CTC Rec - Continuous Tone Coded Squelch
-  Prevents interference from signals on the same frequency.

-  The squelch will open only if the incoming signal is coded with the same tone required by your receiver.
- Note: Not all repeaters requiring a tone for access transmit a tone back to you.
- Leave this function turned OFF unless you are absolutely sure it is needed.
 
 
OFF /
67.0 Hz > 254.1 Hz
16   T-CTC Trans - Continuous Tone Coded Squelch
-  Required by some networks to limit access and interference.
 
 
OFF /
67.0 Hz > 254.1 Hz
17   R-DCS Rec - Digital Coded Squelch
-  Prevents interference from signals on the same frequency.
-  The squelch will open only if the incoming signal is coded with the same tone required by your receiver.
-  Note: Not all repeaters requiring a tone for access transmit a tone back to you. Leave this function turned OFF unless you are absolutely sure it is needed.
 
 
OFF /
D023N > D754I
18   T-DCS Trans - Digital Coded Squelch
-  Required by some networks to limit access and interference.
 
 
OFF /
D023N > D754I
19   PF1-KEY PF1 Side Key
-  CALL:    Selective Call
-  VFTX:    Transmission on Sub-Frequency
 
 
CALL / VFTX
20   PF3-KEY PF3 Side Key
-  SCAN:      Activate Scan
-  LAMP:      Turn On Lamp
-  Tele Alarm:   Remote Alarm
-  SOS-CH:   SOS Function
-  RADIO:     Turn On FM Radio
-  Disable:    Inactive
 
 
SCAN
LAMP
Tele Alarm
SOS-CH
RADIO
Disable
21   CH-MDF Transceiver has 2 Working Modes
-  1) Frequency Mode (FREQ)
-  2) Channel Mode (3 channel modes available)
         Channel (CH)
         Frequency + Channel Number (CH FREQ)
         Channel Name (NAME)

 
 
FREQ or CHAN
22   ABR Automatic Backlight Timer
-  Always ON
-  Backlight Timer  1 > 20 seconds

 
 
Always ON
1 > 20 seconds
23   OFFSET Offset Frequency
-  0 to 599.995MHz

 
 
0 > 599.995 MHz
24   SFT-D Frequency Shift Direction
   +        Possitive Direction
   -         Negative Direction
   OFF    No frequency shift
 
 
+   -   OFF
25   SECOND Stopwatch Timer
-  ON   Activate
-  OFF  Deactivate

 
 
OFF / ON
26   CHNAME Channel Name
-  Composed of 26 letters (A-Z) and 10 numbers (0-9)
-   8 characters max

 
A-Z   0-9
27   MEM-CH Memory Channel
-  999 Channels Available
 
 
1-999
28   DEL-CH Channel Delete
-  999 Channels Available
 
 
1-999
29   SC-CTC CTCSS Scanning
-  In receive mode, press MENU to activate CTCSS Scanning

 
 
SCANNING
30   SC-DCS DCS Scanning
-  In receive mode, press MENU to activate DCS Scanning
 
 
SCANNING
31   SP-MUTE Mute Settings
-  There are 3 Squelch Settings
      QT*DTMF,  QT+DTMF,  QT

 
 
QT*DTMF
QT+DTMF
QT
32   ANI-SW Caller ID Transmission Settings
-   ON:    Activate
-   OFF:  Deactivate

 
 
OFF / ON
33   ANI-EDIT Automatic Keypad Lock
-  Individual Caller IDs can be chosen within the range
      100 > 999999
-  Cannot begin with 0 (zero)
 
 
100 > 999999
34   DTMFST DTMF Sidetone Settings
-  DT-ST   Keypad Sidetone activated when transmitting
-  ANI-ST  Caller ID Sidetone activated when transmitting
-  DT-ANI  Caller ID and Keypad sidetones activated when transmitting.
-  OFF       Deactivate ALL
 
 
DT-ST
ANI-ST
DT-ANI
OFF
35   AUTOLK Automatic Keypad Lock
-  When ON, keypad will be locked if not used in 15 seconds.
-  Pressing the  [#
LOCK]  key for 2 seconds will Lock/Unlock the keys on the keypad.
 
 
OFF / ON
36   PRICH-SW Priority Channel Switch
-  ON    Activate
-  OFF  Deactivate

 
 
OFF / ON
37   RPT-SET Repeater Settings
-  X-DIRPT    Directional Cross Band Repeat
-  X-TWRPT  2-way Cross Band Repeat
 
 
X-DIRPT
X-TWRPT
38   RPT-SPK Repeater Speaker Switch
-  ON    Speaker Active when repeating
-  OFF  Speaker Inactive when repeating

 
 
OFF / ON
39   RPT-PTT Repeater PTT Switch
-  ON     PTT transmission activated when repeating
-  OFF   PTT transmission blocked when repeating

 
 
OFF / ON
40   SCAN-ADD Scan Channel Add
-  ON    When scanning channels, they will be added to the scanning channels
-  OFF  Channels will not be added to the table when scanning

 
 
OFF / ON
41   ALERT Single Tone Pulse Frequency
-  There are 4 single tone pulse frequency options
      1000Hz, 1450, 1750Hz, 2100 Hz
 
 
1000 Hz
1450 Hz
1750 Hz
2100 Hz
42   PTT-DLY PTT ID Delay
Delay can be set at 100ms, 200ms > 30,000ms
 
 
100ms > 30,000ms
43   PTT-ID Caller ID Transmission Mode
-  BOT    Press PTT to send Caller ID
-  EOT    Release PTT to send Caller ID
-  BOTH  Press and Release both send Caller ID

 
 
BOT
EOT
BOTH
44   RING Ring Time
-  1 > 10 levels   Each level = 1 second
-  OFF     Deactivated

 
 
1 > 10
OFF
45   SCG-A Scan Channel Group NO. of A Area
-  Options are:
       SCAN ALL,   Group 1, Group 2 > Group10
 
 
Scan ALL
Group 1 > 10
46   SCG-B Scan Channel Group NO. of B Area
-  Options are:
       SCAN ALL,   Group 1, Group 2 > Group10
 
 
Scan ALL
Group 1 > 10
47   PRT-TONE Repeater Receipt Tone
-   ON    Activate
-   OFF   Deactivate

 
 
OFF / ON
48   SC-QT Saving Scan Mode
-  ALL    Save both Rx and TX   CTCSS/DCS
-  DEC    Save RX   CTCSS/DCS
-  NEC    Save TX   CTCSS/DCS

 
 
ALL
DEC
NEC
49   SMUTESET Setting Sub-Frequency Mute
-  OFF      Deactivate this function
-  TX        Deactivate volume on sub-frequency when transmitting on master frequency
-  RX        Deactivate volume on sub-frequency when receiving on master frequency
-  TX/RX   Deactivate volume on sub-frequency when transmitting and receiving on master frequency

 
 
OFF
TX
RX
TX/RX
50   CALLCODE Selective Call Code Group Setting
-  Selective call     group:  1-20
 
 
1 > 20
51   RESET Reset Setting
-  VFO:    Reset menu functional Parameters
-  ALL:    Reset all (menu and channel) functional parameters

 
 
VFO
ALL
 
 
TOP of PAGE


Miklor Home
 


 


 
US Sales and
Warranty Support


 

Wouxun
KG-UV8D
 
KG-UV9D

 

Blackbird
J-Pole

 
 UV-82
Leixen N8
 

Handheld
Radios
 

Programming Cables

 

POUCHES
 
  
Please
Support
Miklor

 





 
US Sales and
Warranty Support


 

Wouxun
KG-UV8D
 
KG-UV9D

 

Blackbird
J-Pole

 
 UV-82
Leixen N8
 

Handheld
Radios
 

Programming Cables

 

POUCHES
 
  
Please
Support
Miklor