BTech GMRS V1 Programming

outdoors hunting camping SHTF GMRS radio communications antenna battery electronics scanners digital computer software hardware laptop iPad iPhone eBay music radio
.

GMRS V1

Manual Programming

Frequency Mode vs. Channel Mode

These two modes have different functions and often confused.

Frequency Mode - Used for a temporary frequency assignment, such as a test frequency or quick field programming.

Channel Mode - Used for selecting preprogrammed channels.

All programming MUST be done in the Frequency Mode only. From there you have the option of assigning the entered data to a specific channel for later access in the Channel Mode if desired.

This UV82 is certified for GMRS. Additional transmit channels cannot be entered into its memory.

Programming a Receive Channel

This example is for: 162.550 MHz
into channel 6 5

1.   Set radio to VFO Mode (Frequency Mode)
          Press/Hold MENU button during PowerON.
          The radio will respond "Frequency Mode"

2.   Enter RX frequency
        1 6 2 5 5 0

3.   Delete prior channel data
        [Menu]   2 8   [Menu]   6 5 [Menu]   [Exit]

4.   Store Receive frequency
        [Menu]   2 7   [Menu]           [Menu]   [Exit]

5.   Switch back to Channel Mode (MR)
          Press/Hold MENU button during PowerON.
          The radio will respond "Channel Mode"

Adding a Transmit Tone
to a GMRS Channel

This example is for CTCSS Tone: 141.3Hz

1.   Select the desired GMRS channel

2.   Enter the CTCSS tone
        [Menu]   1 3   [Menu]   1 4 1 3 [Menu]   [Exit]
or
        [Menu]   1 3   [Menu]        [Menu]   [Exit]

Adding a Receiver Activation Tone
to any Channel

This example is for CTCSS Tone: 141.3Hz

1.   Select the desired GMRS channel

2.   Enter the CTCSS tone
        [Menu]   1 1   [Menu]   1 4 1 3 [Menu]   [Exit]
or
        [Menu]   1 1   [Menu]        [Menu]   [Exit]

As an Amazon Associate, I earn from qualifying purchases. This helps support the Miklor project.