outdoors hunting camping SHTF GMRS radio communications antenna battery electronics scanners digital computer software hardware laptop iPad iPhone eBay music radio
.

 
  BCH-220
 
  
Menu Definitions
    
 

0    BEEP Keypad Beep
-  Allows audible confirmation of a key press.
 
 
OFF / ON
1    LIGHT Display Illumination Time
-  Time the display stays illuminated.
 
 
 
OFF
2, 5, 10, 15, 20, 25
2   KEY LOCK Keypad locks settings
-  MANU manually locks the keypad when [*lock} is pressed
-  AT  auto locks after x seconds. Resets on power cycle.
-  ATS auto locks after x seconds and remembers settings after power cycle.
 
 
MANU
AT   5, 10, 20, 30
ATS 5, 10, 20, 30
3    SAVE Battery Save
-  Sleep Ratio to acknowledge an RX signal.
-  The higher number increases the RX sleep cycle, but you may miss the first few syllables before the RX opens.
         1=1:1    2=1:2    3=1:3   >  10=1:10
 
  
OFF / 1, 2, 3 > 10 
4    TOT Transmission  Time Out Timer
-  Transmit Times Out after pre-selected time.
-  Radio will alert you when the time is up.
 
 
30, 60, 90 > 600
seconds
5    VOX SWI Voice Operated Transmit
-  Allows transmitter activation by talking only.
 
 
OFF / ON
6    VOX LEV Voice Sensitivity Level
-  Level  1 least sensitive
-  Level 10 is most sensitive
 
 
OFF / 1, 2 > 10
7   PONMSG Boot / Power On Display
   OFF - No PowerOn Message
   DC - Displays battery charge percentage
   MGS - Displays preprogrammed message
       (Entered with software)
 
 
OFF / DC / MSG
8   ROGER Tone at end of transmission
Sends a Tone at the end of each transmission.
     * For Ham use, set to OFF.

 
 
OFF / ON
9   APO Auto Power Off
Turns of transceiver if no activity during a preset amount of time.
 
 
OFF
1, 2, 3 > 24 hours
10   OFFSET Frequency shift amount
-  Specifies frequency difference between TX and RX.
 
 
 
11    WN Wideband / Narrowband
-  Wide = 5 KHz    Narrow = 2.5 KHz
-  For Ham use, start with selecting Wide.
 
 
WIDE / NARR
12   SC MOD Scan Resume Method
-- TO (Time Operation) Scan stops when signal detected.
Scan resumes after approximately 5 seconds (even if the channel is still active).
-- CO (Carrier Operation) Scan stops when signal detected.
Scan resumes when signal disappears.
-- SE (Search Operation) Scan stops when signal detected.
Scanning will not resume.
 
 
TO / CO / SE
13   SC ADD Scan Add / Delete
-- Adds or Deletes a channel from the scan list.
 
 
TO / CO / SE
14   VOICE

Voice Prompt
-  Audible confirmation of a keypad entry.
 
 
OFF / ENG / CHS
15   ANI-ID Automatic Number ID of Radio (set with S/W)
-  Sent when PTT is pressed and/or released.
-  Used to alert dispatcher which field radio was keyed.
-  Used primarily for commercial applications.
 
 
OFF / ON
16   TOP KEY Top Key Function
-  Determines which function is selected when top key is pressed.
 
OFF / SCAN / VOX / MONI / POWER / ALARM / DTMFIN / RADIO / FIRCH / SECCH / SQLOFF / VFO-CH / LED / SQLMOM / 1750Hz
 
 
 
 
  <<<<<
17   PTT ID PTT ID
-  Determines when PTT ID is sent
Beginning, End, Both, OFF
 
 
OFF / BOT /
EOT / BOTH
18   RESET Restore to default settings
-  VFO - Resets all menus to factory default.
   Resets VFO frequencies to factory default.
-  FULL - Same as above.
   Erases all channels.

 
 
VFO / ALL




TOP of PAGE
 
Miklor Home
 
Miklor
 


   


 

 
 
 
BCH-220

1.25cm 5W
 
 BridgeCom

VHF, UHF
1.25cm
Repeaters