Anytone 8R Series
FM Broadcast Mode
TERMN-8R OBLTR-8R
NSTIG-8R
|
The FM Broadcast Radio Mode
TERMN-8R OBLTR-8R
|
The TERMN-8R OBLTR-8R and
NSTIG-8R can all store up to 100
channels in memory via software.
- Enter the FM Broadcast Mode
Press A FUNC
+ 1 FM
If FM does not appear on
the display, press A FUNC
then *
BAND until FM
appears.
If FM OFF is
displayed, press B
MAIN to turn FM ON
- Select the desired mode VFO
or
MR (channel)
C V/M
will toggle between VFO and MR modes
MR - selects channels that were
programmed into memory via software.
(A channel number will appear to the right of the
display).
VFO - allows you to enter desired
frequency using the Keypad.
(A channel number is not present.)
Once you select the desired mode (VFO or FM) you now
have 2 options for changing channels.
Manual: Turning the center selector
knob will advance through the channels one at a time.
Scan: Press A
FUNC then 5
SCAN to
start the scanning cycle.
When a station is found, the scan will stop for 5
seconds, then proceed to the next channel.
Press D ESC
to stop the scan cycle,
Note: If the main receiver detects an
incoming signal, the FM radio will quiet and shift
priority to the incoming signal.
- To Exit the FM Broadcast Mode
Press A FUNC
then 1 FM
The FM Broadcast Radio Mode
NSTIG-8R
|
The NSTIG-8R can all store up to 100
channels in memory via software.
- Enter the FM Broadcast Mode
Press A FUN
+ 1 FM
FM ON will display on the LCD
- Select the desired mode VFO
or MR
D ESC/M
will toggle between VFO and MR modes
MR - selects channels that were
programmed into memory via software.
(A channel number will appear to the right of the
display).
VFO - allows you to enter desired
frequency using the Keypad.
(A channel number is not present.)
Once you select the desired mode (VFO or FM) you now
have 2 options for changing channels.
Manual: Pressing the
B
or
C
will scroll up/down through the channel one at a time.
Scan: Press A
FUNC + 5
SCAN to
start the scanning cycle.
When a station is found, the scan will stop for 5
seconds, then proceed to the next channel.
Press D ESC
to stop the scan cycle,
Press *MAIN
key will temporarily mute the receiver.
Note: If the main receiver detects an
incoming signal, the FM radio will quiet and shift
priority to the incoming signal.
- To Exit the FM Broadcast Mode
Press A FUNC
+ 1 FM
|
|
|
|
|